This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
> I have tried to install netcdf in a new Pc and there were some errors while > installation. > I have also attached the log file. The config.log you attached didn't indicate any build errors. It completed successfully after building all the necessary Makefiles. Error messages in config.log from a successful configure can be ignored, as they result from determining properties of the platform and d3evelopment environment needed to generate the necessary Makefiles. The test-suite.log file you attached also didn't seem to indicate any errors, though I'm not sure what the final line .. contents:: :depth: 2 meant. Did "make check" complete without any actual errors? Warnings and XFAIL messages about expected failures can be ignored. If "make check" didn't complete, then please send us its output, including whatever error message was emitted when it stopped. --Russ Russ Rew UCAR Unidata Program address@hidden http://www.unidata.ucar.edu Ticket Details =================== Ticket ID: MBG-731605 Department: Support netCDF Priority: Normal Status: Closed