This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
Harvey, >Date: Fri, 12 Dec 1997 23:58:27 +1100 (EST) >From: Harvey DAVIES <address@hidden> >Organization: CSIRO Mathematical and Information Sciences >To: Steve Emmerson <address@hidden> >Subject: Re: NEC SX-4 64 bit IEEE Netcdf >Keywords: 199711262243.PAA12321 In the above message, you wrote: > You had me a puzzled for a few minutes as this line is not in fort-misc.c. > It is fort-control.c!! Oops! > > After this change, recompile and retest. If the only errors are the > > "Range error" message, then go ahead and install the package. > > Success!!! 3 cheers for Steve!!! :-) Take care, Harvey. -------- Steve Emmerson <http://www.unidata.ucar.edu>