This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
Perry, >Date: Wed, 22 Oct 1997 09:42:57 -0400 (EDT) >From: Perry Shafran <address@hidden> >Organization: General Sciences Corporation >To: Steve Emmerson <address@hidden> >Subject: Re: 971021: Problem building netcdf library on CRAY C90 >Keywords: 199710211532.JAA26991 In the above message, you wrote: > Steve, > > I again proceeded as suggested, adding these lines to my .cshrc file: > > if ( -f /opt/modules/modules/init/csh ) then > source /opt/modules/modules/init/csh > module load modules PrgEnv nqe > > and then when I sourced the file, this message came up: > > ---------------------------------------------------------------- > > ERROR with modulefile 'nqe': > Couldn't find modulefile 'nqe' in MODULEPATH > > An error occured while processing your module command. > -- Only changes pertaining to the > 'nqe' modulefile were not completed I'd remove the "nqe" from the "module" line. > > ---------------------------------------------------------------- > > Nevertheless, I was able to successfully make and make test this time. Great! -------- Steve Emmersoa <http://www.unidata.ucar.edu>