This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
> Hi there, > > so attached are the outputfiles: > > configure.output = output from running ./configure > --prefix=/gpfs/home/hanson/ginah/netcdf > make.output = output from running make > makecheck.output = output from running make check > makeinstall.output = output from running make install > > To build and install netcdf in 64bit mode, I changed CFLAGS, CXXFLAGS and > FFLAGS to -q64 and NMFLAGS to -X64 in the Makefile. I couldn't find ARFLAGS > and F90FLAGS in the Makefile so I added them and set them to -X64 and -q64 > respectively. I did this after running ./configure and then altered the > Makefile. Gina, I'm not sure, but I think this is incorrect. Could you try setting the flags first, and then running configure? (Make sure you do a "make distclean" first). > > The complier I'm using in the xlf fortran compiler and to my knowledge I'm > using the same one for both netcdf and my model CAM but I haven't set > anything for this as in the default is still being used. Where in my netcdf > output could I check for sure which complier it is using? > > Thanks again for you help and for looking at this stuff for me. Let me know > if I can tell you anything more to help get to the bottom of this problem. > > Gina. > NetCDF is known to build with the xlf compiler. So it does work, we just need to figure out why it is not working for you. Thanks, Ed Ticket Details =================== Ticket ID: HXY-319608 Department: Support netCDF Priority: Critical Status: Open