[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[IDV #NVG-651398]: Donut hole poleward of 30N

This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.

  • Subject: [IDV #NVG-651398]: Donut hole poleward of 30N
  • Date: Wed, 23 Oct 2013 15:04:37 -0600
> Any variable.
> I used air temperature at the 200mb level.
> Same for a wind component at 400mb level.


I tried air temp at the 200mb, not seeing this problem. In general, you can 
check the parameter default range under Tools > Parameter Default Editor, and 
make the adjustment there.



Yuan
> 
> 
> 
> On Oct 23, 2013, at 3:25 PM, Unidata IDV Support wrote:
> 
> >> That loads OK, as the original did.
> >>
> >>
> >> I load it. Good.
> >> I try to create a color-shaded plan view of T200.
> >
> > What is T200? I didn't see this variable.
> >
> >
> > Yuan
> >> It causes a reprojection to lat-lon square.
> >> When I reproject under Projections-> North Pole, I get the donut hole with 
> >> the dateline gap:
> >>
> >> [cid:6cadcb07-9070-4040-9853-4c0e2cfcc7b3@amazon.rsmas.miami.edu]
> >>
> >>
> >> ---------
> >> Second try:
> >> I load your test bundle, uncheck "Auto-set projection", then create T200 .
> >> Now I get the donut hole directly and imeediately.
> >>
> >>
> >>
> >>
> >>
> >>
> >>
> >>
> >> On Oct 23, 2013, at 1:13 PM, Unidata IDV Support wrote:
> >>
> >>>> Perhaps you misunderstood the question.
> >>>>
> >>>> The support form state capture is the problem: it is my attempt to 
> >>>> remake my old bundle with polar displays, this time using the time 
> >>>> driver. It has basic display problems on the polar projection.
> >>>>
> >>>>
> >>>> Yes i know how to use the time driver. The old bundle on ramadda works 
> >>>> fine, but it did not use the time driver. I made it during training in 
> >>>> 2012 with specific times.
> >>>>
> >>>>
> >>>> Brian Mapes
> >>>
> >>> Brian,
> >>>    I downloaded your old bundle and then set the time driver,  and saved 
> >>> a new bundle. See the attached.
> >>>
> >>>
> >>>
> >>> Yuan
> >
> >
> > Ticket Details
> > ===================
> > Ticket ID: NVG-651398
> > Department: Support IDV
> > Priority: Normal
> > Status: Open
> >
> 
> Brian Mapes
> address@hidden or address@hidden
> 
> 
> 
> 


Ticket Details
===================
Ticket ID: NVG-651398
Department: Support IDV
Priority: Normal
Status: Open