This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
=============================================================================== Robb Kambic Unidata Program Center Software Engineer III Univ. Corp for Atmospheric Research address@hidden WWW: http://www.unidata.ucar.edu/ =============================================================================== ---------- Forwarded message ---------- Date: Tue, 29 Dec 1998 21:09:34 +0000 From: Robert Mullenax <address@hidden> To: Chad Johnson <address@hidden> Subject: Re: question about NCEP model data from NOAAport I did make some changes to NOGRIB.CFG, but all I did was to comment out the lines for the Alaskan projections. Maybe I did something to mess it up, (athough I don't see where I changed anything) as I changed NOGRIB.CFG after the first test of NOAAport and before the final switch. At 02:34 PM 12/29/98 -0600, you wrote: >Gilbert Sebenste wrote: >> >> Robert, >> >> I am CC'ing your excellent questions over to ldm-users, since I do not >> know the answer to this. >> >> On Tue, 29 Dec 1998, Robert Mullenax wrote: >> >> > Gilbert, >> > >> > The thing is, during the initial test of NOAAport I received 3-hourly >> > output of the ETA and AVN. When the final switch occurred, just 6-hour >> > output again. I am running McIDAS-XCD, so the decoding is transparent, >> > no long list of headers like GEMPAK. I know the 3-hour output is available >> > as I have seen it on other sites. Are you getting 3-hour output, and is it >> > XCD that is only decoding XCD for me? That would not make a whole lot >> > of sense as on 15 Dec, I received the 3-hour output and did not change >> > anything. > >At SSEC, our NOAAPORT ingestor is receiving 3-hourly forecasts grids >from the MRF in projection 213 out to 24 hours and 3-hourly forecast >grids from the ETA in projections 212 and 215. We are also receiving the >RUC 3-hourly runs. -XCD is decoding all of them just fine. Perhaps you >are not receiving the grid projections that contain 3-hourly forecasts. > >Chad > >-- >Chad W. Johnson E-mail: address@hidden >Programmer/Meteorologist Voice: (608) 265-5292 >Space Science and Engineering Center Fax: (608) 263-6738 >University of Wisconsin -- Madison > >