[McIDAS #XCL-927331]: GINICOMP

Hi Paul,

re:
> Ok here is a bizzare one!
> 
> I use this command:
> IMGDISP GINICOMP/GSN8KIR 1 LAT=41 99 SU=IRTEMP2
> 
> I get a blank image because of this SU
> 
> BREAKPOINTS STORED IN TABLE : IRTEMP.ST
> INPUT       OUTPUT
> -----       ------
> 163           255
> 241.9999      177
> 242           176
> 330           0
> CALIBRATION TYPE  : GVAR
> CALIBRATION UNITS : TEMP
> BAND NUMBER       : -1
> INTERPOLATION TYPE: LIN
> SU: DONE
> 
> When I do *this* command
> IMGDISP GINIEAST/GE4KIR 1 LAT=41 99 SU=IRTEMP2
> 
> There is no problem. I only have a problem with that SU table on GINICOMP
> 
> And this problem is new only within the last few days

I believe that this problem is caused by the CALIBRATION TYPE being
set to GVAR.  If it was blank ("    ") like I noted in a previous
email you should not have the problem.

Cheers,

Tom
--
****************************************************************************
Unidata User Support                                    UCAR Unidata Program
(303) 497-8642                                                 P.O. Box 3000
address@hidden                                   Boulder, CO 80307
----------------------------------------------------------------------------
Unidata HomePage                       http://www.unidata.ucar.edu
****************************************************************************


Ticket Details
===================
Ticket ID: XCL-927331
Department: Support McIDAS
Priority: Normal
Status: Closed