Re: 19990401: LDM product queue disappears when D2D decoders are run

On Thu, 1 Apr 1999, Unidata Support wrote:

> 
> ------- Forwarded Message
> 
> >From: "Molenar, Deb" <address@hidden>
> >Subject: ldm and d2d
> >Organization: CSU/CIRA
> >Keywords: 199904011502.IAA10614 LDM AWIPS D2D
> 
> I'm trying to use the LDM NOAAPORT feed to supply data to one of our
> workstations running the D2D (AWIPS) software.  I'm having problems with the
> interaction between the LDM and the D2D decoders;  the product queue
> disappears when the decoders are started.  

Deb,

So the LDM runs fine until you install the D2D decoders into the pqact
file and try to run the ldm?  If the D2D decoders are using a memory
mapped file, that's what the ldm queue is, then there might be some
interference between the files.  I'm not quite sure I understand the
configuration.


I realize you can't debug D2D
> problems, but was hoping you could point me in the right direction.  What
> would cause the product queue to disappear?  Do you know of anyone else
> who's trying to do this and has had success?

There's another group at UCAR that runs the awips s/w, I'll ask them
about the setup.

Robb...



> 
> Thanks in advance.
> ___________________________
> Debra A. Molenar          address@hidden
> Computer Specialist     NOAA/NESDIS/RAMM  E-RA2
> phone:  970-491-8447    fax:  970-491-8241
> 
> ------- End of Forwarded Message
> 

===============================================================================
Robb Kambic                                Unidata Program Center
Software Engineer III                      Univ. Corp for Atmospheric Research
address@hidden             WWW: http://www.unidata.ucar.edu/
===============================================================================