[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Support #PCD-849276]: With Adaptive Resolution on, after displaying ASCAT wind barns and changing projection, adjusting the Skip incorrectly changes color of barbs. [1930]

This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.

  • Subject: [Support #PCD-849276]: With Adaptive Resolution on, after displaying ASCAT wind barns and changing projection, adjusting the Skip incorrectly changes color of barbs. [1930]
  • Date: Mon, 09 Feb 2015 16:47:36 -0700
> > Hello -
> >
> > I found that there can be a problem with Adaptive Resolution and Match 
> > Display Region on in the IDV where after displaying ASCAT wind barbs, 
> > changing the projection, and then changing the 'skip' between the barbs 
> > causes the barbs to incorrectly change color.  They aren't colored based on 
> > speed at this point, but the coloring is almost random (mostly red).
> >
> > McIDAS-V has this same problem if Adaptive Resolution is turned on.  With 
> > Adaptive Resolution/Match Display Region off, then there are no coloring 
> > issues with regards to changing the 'skip'.  We have set Tom Rink as the 
> > point of contact here at SSEC for this inquiry.
> >
> > Thanks!
> > Bob Carp
> 
> Bob,
> I can see the problem here. I will look into this.
> 
> 
> Yuan

Bob,
     Please test the nightly release available tomorrow morning.


Yuan
> >
> > ----==== Inquiry ====----
> > 1930
> >
> > ----==== Summary ====----
> > With Adaptive Resolution on, after displaying ASCAT wind barns and changing 
> > projection, adjusting the Skip incorrectly changes color of barbs.
> >
> > ----==== Request ====----
> > 2015-02-02 - Bob Carp
> > Note: This is also a problem in the IDV if AR and MDR are turned on.
> >
> > To replicate:
> > 1. Display ASCAT wind barbs colored by speed
> > 2. Make sure AR is turned on (same with MDR in the IDV)
> > 3. Change projection
> > 4. Change the Skip in the Layer Controls
> >
> > ... now, the barbs end up colored somewhat randomly.  There are a lot of 
> > red colors, along with some green, orange, yellow and blue.  They don't 
> > appear to be colored by speed at all, as there are some many barbs of 5kts 
> > through 35kts are colored red, while others that fall in that speed range 
> > are the other colors mentioned.
> >
> >
> > ################################################################################
> >
> > http://mcidas.ssec.wisc.edu/inquiry-v/index.php?inquiry=1930
> >
> >
> 


Ticket Details
===================
Ticket ID: PCD-849276
Department: Support IDV
Priority: High
Status: Closed