[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Ldm has stop receiving data product.

This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.

  • Subject: Re: Ldm has stop receiving data product.
  • Date: Thu, 7 Apr 2005 12:23:20 -0600 (MDT)
Hi Peter,

When did data stop?

I see:

(jweber) lenny:/home/jweber 80 % ldmping atm.geo.nsf.gov
Apr 07 18:20:59      State    Elapsed Port   Remote_Host
rpc_stat
Apr 07 18:20:59 RESPONDING   0.294091  388   atm.geo.nsf.gov
Apr 07 18:21:24 RESPONDING   0.056267  388   atm.geo.nsf.gov


Please do a:

traceroute atm.geo.nsf.gov

from your LDM machine and send the output back to me..I suspect you may
not be on I2 and atm has been delegated to I2 sites only over the past
month..

Cheers,

Jeff
---------------------------------------------------------------------
Jeff Weber                                    address@hidden        :
Unidata Program Center                        PH:303-497-8676        :
University Corp for Atmospheric Research      3300 Mitchell Ln       :
http://www.unidata.ucar.edu/staff/jweber      Boulder,Co 80307-3000  :
---------------------------------------------------------------------

On Thu, 7 Apr 2005, peter Msikela wrote:

>
>
> Hi Jeff,
> I have just found that our ldm at Howard University has stopped receiving
> data product from atm.geo I have.nsf.gov.It was receiving data product
> before but it has suddenly stop.
> I have tried the following :
>    1) i have check the upstream host with ldmping command and i got the
> following messages
>         SVC_UNAVAIL,ADDRESSED and NAMED
>    2) In the case of message  NAMED above i  tried using the IP address of
> atm.geo.nsf.gov but got the same messages.
> Could you help me with that,
>
> Peter
>
>