This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
Mike, What's the result of : % notifyme -vl - -h cirrus.al.noaa.gov It should show something similar to: Sep 14 15:36:32 notifyme[2234]: NOTIFYME(cirrus.al.noaa.gov): OK Sep 14 15:36:32 notifyme[2234]: 18575 19990914153635.765 HDS 514 SDUS53 KTOP 141535 Sep 14 15:36:32 notifyme[2234]: 447 19990914153638.626 IDS|DDPLUS 516 FTUW62 KAWN 141500 RRC Sep 14 15:36:32 notifyme[2234]: 117 19990914153638.675 IDS|DDPLUS 517 UACN10 CYUL 141533 Sep 14 15:36:32 notifyme[2234]: 99 19990914153638.735 IDS|DDPLUS 518 SIVD01 CWHX 141500 Sep 14 15:36:33 notifyme[2234]: 11491 19990914153641.211 HDS 515 SDUS53 KGID 141532 If it shows access denied, then cirrus needs to add an allow statment to the ldmd.conf file. allow UNIDATA|FSL2 ".*" cyclone.natnet.du.edu I checked the IDD archives and located the reply message for Eirh-Yu stating that the configuration has been done. http://www.unidata.ucar.edu/glimpse/idd/3953 I also noticed that you ldm is not running, are you sure it's running correctly? wcfields.unidata.ucar.edu.rkambic> ldmping -i 5 -h cyclone.natnet.du.edu Sep 14 15:53:03 State Elapsed Port Remote_Host rpc_stat Sep 14 15:53:03 SVC_UNAVAIL 0.036421 0 cyclone.natnet.du.edu RPC: Program not registered Sep 14 15:53:08 SVC_UNAVAIL 0.003337 0 cyclone.natnet.du.edu RPC: Program not registered Sep 14 15:53:13 SVC_UNAVAIL 0.004347 0 cyclone.natnet.du.edu RPC: Program not registered Robb... On Mon, 13 Sep 1999, Unidata Support wrote: > >To: address@hidden > >From: Michael Keables <address@hidden> > >Subject: LDM Not Starting > >Organization: . > >Keywords: 199909132239.QAA09888 > > Robb, > > I have LDM installed but am not receiving any data. When starting the LDM > using ldmadmin start, I get the following entry in ldmd.log: > > Sep 13 21:53:53 cyclone notifyme[4187]: Starting Up: localhost: > 19990913215353.4 > 94 TS_ENDT {{ANY, ".*"}} > Sep 13 21:53:53 cyclone notifyme[4187]: NOTIFYME(localhost): RPC: Program > not re > gistered > Sep 13 21:54:22 cyclone notifyme[4187]: Interrupt > Sep 13 21:54:22 cyclone notifyme[4187]: exiting > > What do I need to do start receiving data? > > Thanks in advance. > > -- Mike > > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ > Michael Keables, Ph.D. Email: address@hidden > Associate Professor/Director, Environmental Science Phone: 1-303-871-2653 > University of Denver Fax: 1-303-871-2201 > Denver, CO 80208 USA Aural: "Hey Mike!!" > > Cowboy wisdom: "If you're ridin' ahead of the herd, take a look back every > now and then to make sure it's still there." > > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ > =============================================================================== Robb Kambic Unidata Program Center Software Engineer III Univ. Corp for Atmospheric Research address@hidden WWW: http://www.unidata.ucar.edu/ ===============================================================================