20030116: 20021210: GEMPAK: Soil Temperature/Moisture

Patrick,

That looks like the picture I plot, with values of 1 ringing the
coasts, lakes, etc.

You may want to look at some material describing the use of Soil moisture
and temperature in models, such as:
http://meted.ucar.edu/nwp/pcu2/etsoil1.htm

or the www.emc.ncep.noaa.gov site.

Steve Chiswell


>From: "Patrick O'Reilly" <address@hidden>
>Organization: UCAR/Unidata
>Keywords: 200301161734.h0GHYxx04705

>So, since the SOIM is volumetric soil moisture content in units of
>"fraction", would I be correct that the values will always be between 0-1.0
>with lower values being less moist and higher values showing more soil
>moisture?
>
>Thanks!
>
>----- Original Message -----
>From: "Unidata Support" <address@hidden>
>To: "Patrick O'Reilly" <address@hidden>
>Cc: "Unidata Support" <address@hidden>
>Sent: Tuesday, December 10, 2002 5:43 PM
>Subject: 20021210: GEMPAK: Soil Temperature/Moisture
>
>
>>
>> Patrick,
>>
>> GEMTBL/grid/ tables show for ncep models:
>> SOIM  parameter 144 Volumetric soil moisture content.
>> SLTK  parameter 85  Ssoil temperature.
>>
>> In the NOAAPORT (HRS) grids, NGM grids 202, 207 and 211 carry SLTK at DPTH
>0.
>> ETA 212 carries soil temp and moisture at levels 0-10cm, 10-40cm,
>> 40-100cm, 100-200cm.
>>
>> CONDUIT feed Models that carry SOIM and SLTK  include:
>> ETA grids 212 and 104, RUC grid 236 and 252, AVN grid 3 and
>> MRF grids 2 and 3.
>>
>> When looking for parameters in certain models, you can use gdinfo with
>> GFUNC set to the specific variables, like GFUNC=SLTK;SOIM and
>> GLEVEL, GDATTIM, and GVCORD set to all.
>>
>> Steve Chiswell
>> Unidata User Support
>>
>> >From: "Patrick O'Reilly" <address@hidden>
>> >Organization: UCAR/Unidata
>> >Keywords: 200212102310.gBANAK425407
>>
>> >Hello in Boulder,
>> >
>> >I have browsed the help archives and found a couple tidbits about soil
>data,
>> >but not enough and none too recent.  I am looking to create some plots of
>> >soil temp and moisture and was wondering if this type of product is even
>> >available over the IDD.  If so, where is it located?  I haven't found any
>> >soil parameters in GEMPAK, is what I am looking to do even possible using
>> >only IDD data and GEMPAK?  Any hints, large or small, would be
>appreciated.
>> >Thanks!
>> >
>> >Patrick
>> >_______________________________________
>> >Patrick O'Reilly
>> >Meteorological Decision Support Scientist
>> >The STORM Project - University of Northern Iowa
>> >address@hidden  ~  ph: 319-273-3789
>> >
>>
>>
>****************************************************************************
><
>> Unidata User Support                                    UCAR Unidata
>> (303)497-8643                                                  P.O. Box
>> address@hidden                                   Boulder, CO
>> --------------------------------------------------------------------------
>> Unidata WWW Service                        http://www.unidata.ucar.edu/
><
>>
>****************************************************************************
><
>