This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
>From: weather <address@hidden> >Organization: NMSU/NSBF >Keywords: 200010040248.e942mQb11529 McIDAS-X 7.6x mcscour.sh Robert, >I could not figure out why my disk seemed more full than it >should be until I realized that there were far more ETA grids >than their should be. I then discovered that even though the ETA >grids end with 5620, mcscour.sh stops at 5500 (I just changed it to 6000). >You may already know this, but I just thought I would point it out in case you >did not. Thanks for reminding me. The version of mcscour.sh in 7.6x had not been updated to account for the increased ETA run frequency; it was 5600. I had changed the one in 7.7, but, of course, that has not been released, so it wasn't doing anyone any good. Tom