This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
Frank, > Looks like it ran fine. I saw no errors in the log file from the make > install command, just some warnings about definitions being in the same > place. New directories were created - include, bin, lib, share, and in > bin/ there appear to be all the executables.  I was only asked for > the root password once. Should I be worried about that? Yes. > I've attached the log. > > I ran the configure command with the ellipsis because the installation > web page (long version) showed that. > > I also just noticed that the "Vet the LDM registry" section says to pay > attention to some parameters, one of which, /reconciliation-mode, I > didn't see in the registry listing, either the one linked from the web > page or my own from running regutil. > > Now, going forward, I think something else isn't set right. I have the > system running in a test mode, so am using an ip address for the allow > command from the upstream host and have disabled the sending of stats. > When I tried to start the ldm, this is what I got. > > [ldm@UMLGempak etc]$ ldmadmin start > > The product-queue is OK. > > Checking pqact(1) configuration-file(s)... > > /home/ldm/etc/pqact.conf: syntactically correct > > hupsyslog: couldn't open /var/run/syslogd.pid > > new_log(): Couldn't notify system logging daemon > > start_ldm(): Couldn't rotate log files > > It sounds like a permission problem to me, but the ownership of the log > directory is ldm. > > Thanks, > > Frank > > > HI again, > > One thing I forgot to include in the last email -- the ldmd.log file was > empty. > > Thanks, > > Frank The log files indicate that your installation failed. I'm afraid you'll have to start over. Would you please execute the following commands as the LDM user: cd rm -rf bin etc include lib logs man runtime share src var # assumes that you're not upgrading an existing, working installation wget wget ftp://ftp.unidata.ucar.edu/pub/ldm/ldm-6.12.6.tar.gz gunzip -c ldm-6.12.6.tar.gz | pax -r '-s:/:/src/:' cd ldm-6.12.6/src ./configure >configure.log 2>&1 && echo Configured # assumes you're using a standard-conforming shell (e.g., bash(1)) # answer the prompt for the root password or the LDM user's password make install >install.log 2>&1 && echo Installed # answer the prompt for the root password or the LDM user's password If an error occurs then send me the details. If "Configured" or "Installed" isn't printed, then send me the associated log file. Regards, Steve Emmerson Ticket Details =================== Ticket ID: YLA-231641 Department: Support LDM Priority: Normal Status: Closed