This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
>From: mynul khan <address@hidden> >Organization: St. Cloud State >Keywords: 200408050000.i7500GaW005480 LDM build Mynul, >First of all, thank you very much for your prompt >reply yesterday. No worries. >Today I resumed where I left of >yesterday. I followed your instructions and seems we >avoided the problems that we had earlier. But still we >have more fatal errors in make.log. >I would very much appreciate if you could help me out >with this. >By the way, I work for Earth and Atmospheric Science >Dept. at St. Cloud State University. Since you work for St. Cloud State, and since St. Cloud State is not a major IDD relay node, there is no reason that you need to build the LDM with large (> 2 GB) queue support. Give this, I advise that you do the following: 1) undefine all relevant defines in the environment in which you are building the LDM (i.e., CFLAGS, CPPFLAGS, LIBS, etc.) 2) remove the entire ~ldm/ldm-6.0.14 directory tree and start a bulid from scratch: cd ~ldm zcat ldm-6.0.14.tar.Z | tar xvf - cd ldm-6.0.14/src ./configure make make install sudo make install_setuids The only problem you could run into is if your development environment is non standard. >Thank you, >-Mynul Cheers, Tom -- NOTE: All email exchanges with Unidata User Support are recorded in the Unidata inquiry tracking system and then made publically available through the web. If you do not want to have your interactions made available in this way, you must let us know in each email you send to us.