[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

20030924: getting LDM running (cont.)

This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.

  • Subject: 20030924: getting LDM running (cont.)
  • Date: Wed, 24 Sep 2003 08:38:13 -0600
>From: Dave Santek <address@hidden>
>Organization: SSEC
>Keywords: 200309241344.h8ODi0k1028772 LDM install start
>    
Hi Dave,

re: >How can I convince you to build and install LDM-6.0.14 on chinook?

>By saying you're trying to move away from version 5....which you did below!

That was easy enough :-)

>I'll give it a try......should I totally remove the binary install?

Yes.  I would clean out the binary installation tree and, just for
good measure, remove the etc directory and its contents.

re: why to do the steps that you did not do

>But, we have other systems here where these seemingly were not done. [At 
>least according to Jerry!]

Well, the point is that if things are done according to the installation
instructions, then we don't have to spend additional time troubleshooting
problems that can be avoided.  I am sure that you understand this
from your years of McIDAS support.

>thanx

No worries.

Tom