This archive contains answers to questions sent to Unidata support through mid-2025. Note that the archive is no longer being updated. We provide the archive for reference; many of the answers presented here remain technically correct, even if somewhat outdated. For the most up-to-date information on the use of NSF Unidata software and data services, please consult the Software Documentation first.
On Wed, 24 Mar 1999, William H. Highlands wrote: > Hi Robb, > > As you know, last night the NWS NOAAport broadcast stopped. We first > assumed that it was our equipment and did a shut down and reboot. After > doing this we found out that the NWS was a fault and waited until they came > up to see if our equipment was all right. > > Upon the NWS being restored, we could not get the LDM to run properly. It > complains about a spool overflow and the delq and makeq commands do not > seem to operate. Hiya Bill, I think the reboot left the pid around so ldmadmin would not let one do a delqueue. I delete the ldmd.pid file then the delqueue, mkqueue and a start succeeded. nport is now receiving data. Robb... > > Could you take a quick peek at it and see if there is something you can > determine that is wrong. Any assistance would be appreciated. > > Bill > > William H. Highlands > Alden Electronics, Inc. > Vice President Operations > 508 366 8851 ext2408 phone > 508 366 3898 Fax > 40 Washington St. Westborough, MA 01581 > email:address@hidden > =============================================================================== Robb Kambic Unidata Program Center Software Engineer III Univ. Corp for Atmospheric Research address@hidden WWW: http://www.unidata.ucar.edu/ ===============================================================================