[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: space products



On Wed, 6 Dec 2006, Simon Elliott wrote:

> Good morning Robb,
>
> I think I see the problem ... you need to use template 4.30 not 4.3
>
Good evening Simon,

After checking the code, i made the mistake but the code actually used
template 4.30.  the code was written so the superset of variables are
available, even if the variables are not set. that was my problem..

thanks,
robb...




> These templates are quite different despite the numbering.  The "4"
> is indicating that we are talking about Product Definition Templates
> rather
> than Grdi Definition Templates (all 3.something) or Data
> Representation
> Templates (all 5.something).  The figure after the decimal point should
> not
> be considered like a decimal fraction, but as the identification of
> the
> particular template as given earlier in the relevant Section.
>
> Simon
> >>> Robb Kambic <address@hidden> 05/12/2006 17:11:50 >>>
> Simon,
>
> Do you have newer documentation? Because both the NCEP and EUMETSAT
> docs
> for template 4.3 have bytes 23-34 designated for 1st and 2nd fixed
> surfaces. I understand that these values are probably not used in
> space
> products.
>
> robb...
>
>
>
> ===============================================================================
>
> Dr Simon Elliott
> Product Implementation Manager
> Operations Department
> EUMETSAT
> tel: (+49) 6151 807385
> fax: (+49) 6151 807304
>

===============================================================================
Robb Kambic                                Unidata Program Center
Software Engineer III                      Univ. Corp for Atmospheric Research
address@hidden             WWW: http://www.unidata.ucar.edu/
===============================================================================